| |
    
Doc Tuscola, IL March 3, 2010 |
FEMALE 1/4-20 THREAD 1
I have used this particular ball for numerous mounting situations where I previously used the wider based mounting for the 1" ball. It allows the use of smaller mounting surfaces, such as 3/4" square tubing and in some cases 1/2" and 3/4" round tubing. Unless I need to spread a significant torque load over a large surface, this mount is my choice.
Recommend: YES
5 viewers found this helpful. Was this review helpful to you?
Yes
No
|
| |
    
rtrider California February 5, 2010 |
DOES THE JOB
used this to put a Ram long arm on an Ultra-pod base clamp plus Ram large camera thread base plate for mounting a camera on my motorcycle. The metal female thread base is stout enough for the job.
Recommend: YES
6 viewers found this helpful. Was this review helpful to you?
Yes
No
|
| |
    
ConTeacher SoCal May 26, 2009 |
GREAT FOR HOME-MADE MOTORCYCLE MOUNT
I used this ball to mount on a home-made bracket on my offroad motorcycle. It worked like a charm.
Cons: none Recommend: YES
30 viewers found this helpful. Was this review helpful to you?
Yes
No
|
| |
    
Vince San Jose May 18, 2009 |
IT WORKS
The ball itself works great.But by the time you get it with the cost of the part and then the cost of shipping.15 bucks is a lot of money for a little ball.
Pros: the part is good Cons: the shipping cost to much.through a stamp on Recommend: YES
31 viewers found this helpful. Was this review helpful to you?
Yes
No
|
| |
    
William O'Neal November 18, 2008 |
BALL MOUNT FOR HOBIE I12S
I have a hobiecat inflatable kayak which has accessory plates using 1/4-20 screws. I fastened this mount to the plate to attach a GPS and a cup holder. It works great and allows much flexibility in positioning the items.
Recommend: YES
41 viewers found this helpful. Was this review helpful to you?
Yes
No
|
|